 |
About us |
|
|
Mist Maker |
|
|
Humidifier |
|
|
Diffuser |
|
|
About Fogger |
|
|
Contact Us |
 |
|
About MIST MAKER Ultrasonic Mist Maker generates a water mist without raising its temperature. An electronic oscillation is converted to a mechanical oscillation by using a ceramic disk immersed in a reservoir of water. The mechanical oscillation is acting directly at the surface of the water, so that a very fine mist of water droplets will be created at very high frequencies. This adiabatic process, which does not heat the supply water, reduces energy use by 90% to 93% compared with systems that boil the water. The mist contains a large number of negative ions, which helps to freshen the air. If you pour several drops of aromatic oil into the water, the air will be as fresh and natural as that of a forest. Mist makers can be provided in different sizes. The ceramic disk has a working life of approx. 3000 hours and is replaceable. Its lifetime also depends on water quality. You should clean the disk with soft cloth or cotton sticker in clean water when it is dirty. Don't put your hands above the ceramic disk while it is working, otherwise the high frequent vibration can hurt your hands. It is not an electric shock, but mechanical shock. The mist maker will stop working automatically, when the water is not enough to drown the top of the sensor switch.
No matter where you get the ultrasonic unit, the following advice should be followed: · Never put your hands or other body parts near the "business end" of the mister. It can drive water under your skin, causing damage that feels like a burn. · Had better use only distilled or demonized water. Tap water will leave mineral deposits that may gum up the unit. · Never run the unit "dry". Don’t connect transformer’s plug into in the supply socket, when mist maker is dry, otherwise, a pulse current may damage the ceramic disk .Mist maker will work at good case when the distance from disk to the water surface is about an inch of over it. Water Level Sensor
Ultrasonic misters must be covered with water. They can burn out if there isn't enough water. In order to prevent catastrophic failure when the water level gets low, our ultrasonic misters include a water level sensor or more water level sensors that automatically turn off the unit when the water level is low. Mineral DepositsIf your unit is gummed up by mineral deposits, you can clean it with distilled water and some white vinegar.
|
